Complete HVAC & clean room services, under one roof
Design, installation, testing and maintenance — every service below is delivered by our own engineering and site teams.
HVAC Design & Engineering
Every project starts with the building, not the catalogue. Our engineering team studies occupancy, orientation, and process loads to size chillers, AHUs and duct runs correctly the first time, then hands over coordinated MEP drawings your contractor can actually build from.
- Heat load calculation & equipment sizing
- HVAC layout, ducting & piping drawings
- Energy-efficiency and life-cycle cost review
- Coordination with architects & MEP consultants
VRF / VRV Systems
VRF/VRV systems give every floor and every tenant independent temperature control while keeping outdoor footprint and energy use low. We design refrigerant piping, indoor unit layouts and controls, then install and commission the full system.
- Multi-zone VRF/VRV design & installation
- Refrigerant piping & branch selector layout
- BMS-ready controls integration
- Load-based indoor unit selection
Chilled Water Piping & Chiller Plants
For buildings that outgrow packaged units, we engineer and install complete chiller plant rooms — chillers, pumps, cooling towers and insulated distribution piping — sized and balanced for reliable, efficient central cooling.
- Chiller & cooling tower selection and installation
- Primary/secondary chilled water piping networks
- Pump sizing, insulation & pressure testing
- Plant room layout for serviceability
Ducting & Ventilation Systems
Ductwork is where good design either survives or falls apart on site. Our fabrication and installation crews work to design airflow and pressure targets, with proper insulation, sealing and diffuser balancing throughout.
- Sheet metal ducting fabrication & installation
- Supply, return & fresh-air ventilation systems
- Duct insulation & acoustic lining
- Diffuser, grille & damper balancing
AHU & FCU Installation
We install air handling units and fan coil units per the approved design, including structural mounting, ducting connections, drainage and electrical tie-ins, so airflow and temperature stay consistent across every zone.
- AHU & FCU positioning and mounting
- Ducting, piping & drain connections
- Filter, coil & fan verification
- Post-installation performance checks
Cleanroom System Design & Validation
Cleanrooms demand precision beyond standard comfort HVAC. We design and install HEPA-filtered, pressure-cascaded systems for pharmaceutical, healthcare and industrial cleanrooms, then validate them with the documented test data your compliance team needs.
- ISO 5–9 and Grade A–D cleanroom HVAC design
- HEPA filter installation & integrity testing
- Room pressurization & cascade control
- Particle count, airflow & recovery validation
Testing, Balancing & Commissioning
Installation isn't finished until it's measured. We test and balance every system before handover — airflow velocity, pressurization, HEPA integrity, particle counts, and light and noise levels — with documented results.
- Air velocity & airflow volume testing
- Pressurization & filter integrity testing
- Particle counting for cleanroom areas
- Light and noise level assessments
HVAC Maintenance & AMC Services
A well-installed system still needs upkeep. We offer structured annual maintenance contracts covering filter changes, coil cleaning, refrigerant checks and performance audits, so your system keeps running efficiently long after handover.
- Scheduled preventive maintenance visits
- Annual Maintenance Contracts (AMC)
- Filter, coil & refrigerant servicing
- Breakdown support & spare-part guidance
Planning an HVAC or cleanroom project?
Talk to our engineering team about design, installation or AMC support — we'll respond with a clear scope and quote.